Possibly one of the most dreaded cleaning chores you had to was to clean your bath and shower tile. These can get very dirty with slimy, moldy debris that can accumulate if these are not cleaned right away. One way to clean these in a more efficient manner is to power wash.
If you have never power washed your walkway or driveway then you can certainly use this technique indoors in the bathroom. You can use your pressure washer’s intense water jet and apply it to indoor tile. Because of a lot of pressure, it can clean better than a steam cleaner. Are you thinking that it can damage your tile? A power washer can leave the tile totally unscathed.
This is a relatively simple and low-labor project that will save you a lot of time and effort when cleaning an entire shower or tub than using a manual scrubbing.
How to Use a Power Wash for Your Indoor Tile
1. Protect the floor and ceiling before you even begin
Place plastic sheeting on the floor and ceiling to keep the space drier, but it will never remain completely dry. If you have floors that cannot tolerate moisture like engineered wood, solid hardwood, or laminate then power washing may not be a good idea. You must be cautious with refinished, or reglazed, tile and tubs because the finish or paint may chip away.
2. Locate the pressure washers
Do not operate gas-powered washers indoors. Carbon monoxide may accumulate inside a room, especially something as enclosed as a bathroom. And due to water leakage in the connections, you’ll want to keep the electric power washer outdoors. And if you not yet have an electric power washer in your bathroom, you can check out one from a completed review list on 10techy today.
Check Price on Amazon.com
3. Open your bathroom window and run the hose in
Keep the bathroom window open for a few hours to promote drying. Place the power washer close to the bathroom window outside your home. Plug it into the nearest outlet and run the hose and sprayer through the bathroom window. Again, never place the washer indoors.
4. Widen the spray stream to reduce the pressure
One of the most important things to consider is the danger of chipping away the grout. Pressure washers are strong enough, therefore, you must keep the spray in a medium-wide position. Widening the spray reduces the pressure you may otherwise use an inexpensive model with adjustable psi settings.
5. Be careful of overspray
Because you are using a power wash tool, you want as much water as possible to drain back to the tub and down the drain. But there is always a possibility of overspray with water ending on your floor.
Reduce overspray by never pointing the end of the hose perpendicular to the tile. Be mindful of the water stream by keeping it in a 45-degree angle and always point it down or sideways. You must also have a few towels to hold off the water.
You can also reduce overspray by placing plastic sheeting in front of the tub or shower. Use zip wall poles to stable the plastic sheets or tape it to the ceiling instead. The bottom of the plastic should be tucked into the tub, so that water will drain back into the tub. Extend the sheeting 12 inches up the wall to shield the lower section of the walls and prevent water from spreading to the baseboards.
6. Be very careful of caulking
Aside from the grout, caulking is another thing that could be stripped away by the power of the power washer. If the caulking is not in good condition to start with then you may choose to spray with all your might since you may have to re-caulk the tub or shower after you are done. You can also widen the spray to reduce pressure to run the spray across the caulking. The final option for very bad or ready to shatter caulking is to keep the spray moderately wide, to just entirely steer clear of it.
7. Start washing from the top going downwards
Spray from the top of the tile, working in horizontal runs. After a complete run, move down 6 inches and proceed with another run. Starting at the top, you prevent debris keeps moving downward, away from already clean tiles.
8. Time to clean up
Expect a lot of debris and residue that will collect on the tub, soap dishes, and other horizontal surfaces. Don’t shoot areas with the power washer remove the residue. Remove any kind of residue because these will only harden again.
– Natural Bathroom Cleaning